Learn / Reading a symptom
Reference
Describe what you observe.
Before changing a value, describe the symptom properly: where it appears, since when, what the measurement says. A good description is half the diagnosis.
Chatter
Noise and regular marks on the surface guide your observation, but they don’t tell you the cause on their own.
1 · Observe and note
- In which operation and on which surface does it appear?
- Did it start after a change of tool, clamping or stock?
- Does the measurement confirm a problem, or are you only looking at appearance?
2 · Where is it?
For a bore, note which boring bar and holder you use and the planned overhang.
For an outside surface, note the machined area and how the part is supported in that operation.
3 · Hypotheses to check
Things to compare: overall rigidity, part and tool overhang, how the part is supported. In boring, the bar overhang matters a lot. These are hypotheses to check on your own case.
Hard-to-control chips
A long or tangled chip is a symptom to link to material, tool and operation.
1 · Observe and note
- Does it happen in roughing, finishing or another operation?
- What is the material and the exact insert designation?
- Are the cutting data within the insert maker’s recommended range?
2 · Where is it?
In a bore, also describe how much room the chip has to get out.
On the outside, describe where it tends to build up, and never reach in while the machine is moving.
3 · Hypotheses to check
Chipbreaker, nose radius, feed and depth of cut decide how the chip forms. Compare the whole set with the tool data: changing one value blindly is not a solution.
Poor surface finish
A surface that isn’t as expected must be described and measured against what the drawing requires.
1 · Observe and note
- Is it measured roughness, visible scoring or a dimension out of tolerance?
- Which drawing requirement are you comparing it with?
- Compared with before, did the insert, allowance or cutting conditions change?
2 · Where is it?
In a bore, separate the size requirement from the roughness requirement and state where you measure.
On the outside, describe where the marks appear and which requirement must be checked.
3 · Hypotheses to check
The insert geometry must suit the type of cut: a roughing geometry used for a light pass can give a worse finish. Also check the condition of the cutting edge.