Learn / Lesson 02
Lesson 02 · 12 minutes
Workholding and sub-spindle
What changes when the part moves from the first to the second operation: clamping, locating and transfer.
Tell apart what holds the part from what locates it, and read a transfer without mistaking it for simply “flipping the part”.
01
What is holding the part?
The spindle is the rotating unit; the device mounted on it, for example a three-jaw chuck or a collet, is what actually holds the part. On the shop floor people say “chuck” or “spindle” for both: on a setup sheet it pays to keep them apart.
Seeing the part inside the jaws isn’t enough: the workholding must support it during cutting and leave the surfaces to be machined accessible.
02
Clamping and locating are two different things
Clamping holds the part. Locating defines where it sits relative to the machining: for example a diameter for centring and a face against a stop for the Z position.
If you re-clamp a bushing without deciding which face goes against the stop, you no longer know where to measure the length from. On the process sheet always write the clamping surface and the datum of each operation.
03
Three states to recognise
First operation: the part is in the main spindle. Transition: the cycle coordinates the handover to the sub-spindle. Second operation: the sub-spindle supports the part while the second side is machined.
The transfer can happen in different ways, even with the part rotating. Synchronisation, clamping confirmations and permissives are specific to each machine: the diagram helps you recognise the states, it is not a command sequence.
04
Bar stock or blanks: the reasoning changes
If the part comes from bar stock, the cycle usually includes a part-off to separate it. If you load pre-cut blanks, that step may not be needed.
Don’t copy the sequence of a bar-fed part onto a part loaded one by one: always ask which material is still attached to the part and which surfaces are left to machine.
05
Workholding affects quality
A thin-walled part can distort if you clamp it too hard. A long overhang reduces rigidity and invites chatter. Jaws, contact surface, part shape and speed have to be weighed together: there is no pressure that suits everything.
The workholding manufacturer’s data sheets give the limits (clamping force, maximum speed). They are limits, not the value to use: the right value depends on the part.
?
Think it through: re-clamping a bushing
- The bushing has its outside diameter already finished and one face still to machine.
- Where does the second clamping happen, and how do you protect the finished surface?
- Which datum lets you check the length?
The answer depends on the drawing and the workholding. The outcome of the exercise is a written decision on the sheet: clamping, datum and inspection for that operation.
✓
Test yourself
Three quick questions. Get them all right and the lesson is marked as completed on this device.
What defines the datum of an operation?
Is the maximum chuck pressure always the one to use?
What do you need to plan the re-clamping of a bushing?
Lesson completed.
≡
Take it to the shop floor
- Clamping, locating and access are read together.
- The transfer changes what supports the part.
- Two spindles alone don’t guarantee a good second operation.
↗
Further reading
Machine builders’ pages are quoted as examples: for your machine, always follow the manual and data sheets of the specific model.