Learn / Lesson 04
Lesson 04 · 12 minutes
Finding your way in the CNC control
Give meaning to coordinates, work offsets and tool offsets before reading a program.
Tell the work offset apart from the tool data and read the program as a sequence of intentions.
01
Coordinates need a reference
A dimension in the program only means something relative to a coordinate system. On a lathe, for the basic axes, Z is parallel to the spindle axis and X is radial.
Positive directions, channel names and conventions vary between controls. For X you also need to know whether it is programmed on diameter or radius: the same number, read wrongly, scraps the part.
02
Work offset and tool offsets
The work offset links the datum chosen on the part to the machine coordinate system. Tool offsets tell the control where the cutting edge is relative to its reference.
They are different pieces of information: moving the zero from one face to the other concerns the part; fitting a tool with a different geometry concerns its offsets. The exact procedures depend on the control.
03
Geometry and wear
Many controls keep tool geometry separate from wear offsets. Wear is for small adjustments in production, but it doesn’t explain on its own why a dimension has drifted.
Before adjusting, ask: is the measurement reliable? Has the tool changed? Is the part clamped properly? Is the machine warmed up? Correcting at random hides the problem.
04
Read a program by intentions
First identify which tools and which work offsets are called; then approaches, cuts and retracts. On multi-channel machines also look for waits and synchronisation between turrets.
A line can’t be read in isolation: many functions stay active until they are changed (they are called modal). To understand a block you need to know what is active at that moment.
05
Units are part of the number
A feed can be per revolution or per minute; speed can be fixed RPM or constant surface speed, if the control supports it. A value without units and without the active mode tells you nothing.
Exercise: next to every number you meet, write “what does it measure?” and “in what unit?”. It sounds trivial, but it prevents the most expensive mistakes.
06
What a simulation tells you
A simulation shows the toolpath in the model you configured. It is only as good as the data in it: stock, tools, holders, jaws, kinematics.
If a holder’s overhang is missing from the model, “no collision” doesn’t mean that area is clear on the machine. Simulation helps; it doesn’t replace checks on the machine.
?
Exercise: match the sheets
- Sheet 1 · the zero on the part face.
- Sheet 2 · the geometry of a tool.
- Sheet 3 · a feed written without units.
Match the first to the work offset and the second to the tool data. On the third, write the missing information before interpreting the value.
✓
Test yourself
Three quick questions. Get them all right and the lesson is marked as completed on this device.
Do work offset and tool geometry mean the same thing?
To interpret a feed you need to know…
Does a collision-free simulation guarantee the real machine?
Lesson completed.
≡
Take it to the shop floor
- Every dimension makes sense relative to a reference.
- Work offset and tool offsets are different information.
- Units, active modes and simulation completeness must always be checked.
↗
Further reading
Machine builders’ pages are quoted as examples: for your machine, always follow the manual and data sheets of the specific model.